![]() Once you can see that no more air bubbles are forming on the cover, the hose is ready. Pump water onto the pool cover to completely eradicate all the air bubbles inside the hose to ensure the water flows properly. If necessary, weigh it down with something but do not block the throat of the pipe entirely. Step two: Submerge the other end under the water completely Make sure it is in good working order with no kinks or bends anywhere. ![]() Step one: Attach your hoseĪttach one end of your garden hose to your outside faucet. However, it is helpful for those that may not have a pump to remove the excess water. Siphoning away the excess pool water manually takes a bit longer and might be challenging for some. Your pool cover is now drained and ready to be rolled back for the pool season. Once the water has drained, remove the pump, wipe it down as best as you can, and store it safely. This might seem unnecessary, but it is important because your pump could burn out if the water is not getting drained or there is a blockage in your garden pipe. When you turn on your pump, monitor it to ensure the pool water is properly draining. If you have a semi-mesh pool cover, place the pump on top of a lid, so it doesn’t drain your pool water. Place the pump under the water on top of the pool cover, and plug it into a grounded electrical outlet. Step three: Put the pump on top of the pool cover You could drain it into a bucket or a pot and reuse the water if you’re keen on recycling and saving money. It also pays off to check that there aren’t any blockages like ice or debris build-up, or it may pop off underwater! Step two: Find a good location to drain the water from the other end of the hoseĪngle the other end in an area where the excess water can drain away safely. When connecting your hose to the pump, make sure the hose is in good working condition and firmly attached with no bends in the pipe. Pool Cover Pump (Sump Pump) Step one: Connect your hose to the pump The last one is the most effective method, so let’s review it step-by-step. You have various options for removing the water, such as manually scooping it up using a bucket, siphoning it off with a simple garden hose, or using a pool cover pump. Step-By-Step: How to Remove Water From Your Pool Cover Debris, such as leaves and twigs, add to the weight, so you should also remove them regularly. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |